Detailing - Civil Snapshot

Classification of bolted connections

August 24, 2022August 24, 2022 - by Kathir - Leave a Comment

The classifications of bolted connections are made based on resultant force transferred, type of force and force mechanism. Based on resultant force transferred: Concentric connections: When a load of …

Do’s for Detailing

September 18, 2019September 18, 2019 - by Kathir - 1 Comment

Do’s for Columns A reinforced column should have min 4 bars for rectangular or square column and minimum 6 bars for circular columns. Keep outer dimensions of the column constant, …

Do’s and Do Not’s for Detailing

August 11, 2019August 11, 2019 - by Kathir - 2 Comments.

Do’s for Detailing Prepare drawing properly and accurately Prepare bar bending schedule, if necessary Indicate proper cover to the reinforcement Decide location of the openings/hole and supply adequate details for …

Requirements of Good Detailing

July 22, 2019July 22, 2019 - by Kathir - 2 Comments.

Should be simple for fabrication and placing Check spacing for crack control – maximum spacing Minimum spacing for concrete placing Check for splicing requirements and development length Special care for …

Requirements of Structural Detailing

April 18, 2019April 18, 2019 - by Kathir - Leave a Comment

Simple for fabrication and placing The crack width must be within acceptable limits under service conditions. There should not be any free path for the propagation of the cracks without …