Requirements of Good Detailing

Should be simple for fabrication and placing

Check spacing for crack control – maximum spacing

Minimum spacing for concrete placing

Check for splicing requirements and development length

Special care for section of varying depth and sloped slabs

Care for corner joints, beam column junction, openings etc.

Detailing for gravity loads is different from the lateral loads especially for the SEISMIC FORCES.

Apart from the detailing for the above there is a different detailing required for the rehabilitation and strengthening of damaged structures.

Detailing codes SP16 and IS456-2000.

EQ code is 13920 as required for seismic forces.

 

2 Comments on “Requirements of Good Detailing”

Leave a Reply to ASHRAFUL Cancel reply

Your email address will not be published. Required fields are marked *